article thumbnail

Leaker compares 3D-printed ‘iPhone 14’ fashions to iPhone 13 equipment

Posted on




AppleInsider is supported by its viewers and will earn fee as an Amazon Affiliate and affiliate accomplice on qualifying purchases. These affiliate partnerships don’t affect our editorial content material.

A set of purported 3D-printed “iPhone 14” fashions have been positioned in current iPhone 13 equipment to see how gadget dimensions are anticipated to alter.

Leaked diagrams have given method to mockups and 3D-printed fashions which will present some perception into simply how a lot the brand new gadget designs will change. The brand new fashions have been paired with iPhone 13 instances and display protectors to confirm the anticipated adjustments, reminiscent of a bigger digicam bump, and thinner show bezel.

The brand new mockups have been supplied by Alibaba sources to Mac Otakara, with one for every new anticipated gadget dimension. A brief video was then made exhibiting every mannequin intimately.

There are molds for the 6.1-inch “iPhone 14” and “iPhone 14 Professional,” and molds for the 6.7-inch “iPhone 14 Max” and “iPhone 14 Professional Max.” As anticipated, the adjustments to the digicam bump for the professional fashions made them bigger and thicker, so no instances would match.

The rear digicam for the “iPhone 14” mould is 30.10mm tall versus the iPhone 13 at 28.84mm with a barely thicker digicam bump too. The case could not match the physique both, for the reason that dimensions have been barely bigger as properly.

Nevertheless, the “iPhone 14 Max” was in a position to slot in the iPhone 13 Professional Max case for the reason that digicam bump is smaller by comparability and the physique dimension is identical. It’s because it will get the identical digicam bump discovered on the smaller iPhone 13, however the bigger dimension of the iPhone 13 Professional Max

The molds have been in comparison with current equipment

The rear digicam for the “iPhone 14 Professional” is 38.24mm tall versus 36.24mm for the iPhone 13 Professional. The physique dimension was additionally barely bigger for this mould as properly.

The “iPhone 14 Professional Max” mould match the iPhone 13 Professional Max case across the physique, however the digicam bump was about 2mm taller as properly. So, the case would not match utterly.

The display protectors did not fairly align with the shows on any mannequin both, with the leaker noting that the show gave the impression to be “thinner” on the mockups. The professional fashions are anticipated to have hole-punch shows, so the cutouts weren’t proven on the mockups.

Given this info, Apple appears to be growing the physique dimensions for its 6.1-inch fashions, however not for the 6.7-inch fashions. Nevertheless, the digicam bumps are growing in dimension general.

Apple usually offers molds and diagrams to some accent makers early to make sure all kinds of instances can be found at launch, and people firms are typically much less combative towards leaks. The “iPhone 14” lineup is predicted to launch in September at an Apple occasion.



Supply hyperlink

Leave a Reply

Your email address will not be published.